1-5
Cross cut unit .........................Used for separating media or for crosscutting.
Pen station/Pen holder (option 2-pen type only)*
.........................A second pen is set.
* Pen station is an optional item. For details, please contact your dealer.
Rear view
This will be explained in FC9000-140.
AC line inlet
Stopper
Push roller hold-down force
switching lever
Stock shaft
Stand
Basket
Media stocker
Network (LAN) interface
connector
USB interface
connector
RS-232C interface
connector
USB memory dedicated
connector
Media sensors
AC line inlet ............................. Inlet where the power cable is connected.
Push roller hold-down force switching lever
.........................Switches the hold-down force of the push roller to 3 stages of strong, medium
and weak.
Media stocker .........................The stock shaft is set.
Stock shaft ..............................A roller that takes in roll media.
Stopper ....................................Keeps set roll media in place.
USB interface connector .......Used to connect the plotter to the computer with a USB interface cable.
RS-232C interface connector
.........................Used to connect the plotter to the computer with a RS-232C interface cable.
It depends on the sales area. For details, please contact the distributor where
you purchased.
Network (LAN) Interface connector
.........................Used to connect this plotter with a network (LAN) I/F.
USB memory dedicated connector
................................................USB memory dedicated connector.
Stand .......................................A stand to put the machine on.
Basket ......................................The container for receiving the media.
To Next Page
Loading...
