GRAPHTEC FC9000-140 - Start Mark Auto Scan

12-8
12.4
Start Mark Auto Scan
When the start mark auto scan is set to ON, the following operation is performed.
If the tool is close to the start mark, pressing the [ENTER] key will automatically scan the start mark without
moving the tool to the scan start position.
Supplement

It is available only for the start mark of "standard barcode". For "Roll Paper Barcode" it is not available.

,IDPDVNUHJLVWUDWLRQPDUNLVEHLQJSORWWHGWKHUHLVDSRVVLELOLW\WRUHFRJQL]HWKHPDVNUHJLVWUDWLRQPDUNDVDVWDUWPDUN,IDPDVN
registration mark is being plotted, set the start mark auto scan to OFF.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (LINK).
DATA LINK screen (1/2) is displayed.
3
Press the POSITION ( ) key.
DATA LINK screen (2/2) is displayed.
4
Press the [1] key (START MARK AUTO SCAN).
START MARK AUTO SCAN screen is displayed.
5
Press the [1] key (ON) or the [2] key (OFF).