GRAPHTEC FC9000-140 - Structure of Cutter Plunger

2-3
Structure of cutter plunger
PHP35-CB09-HS/
PHP35-CB15-HS
Cutter blade
ѮPPѮPPGLDPHWHU
Plunger
Chuck
%ODGHOHQJWKDGMXVWPHQWNQRE
(blue) / (red)
Protective cap
Hole
PHP33-CB09N-HS/
PHP33-CB15N-HS
Cutter blade
ѮPPѮPPGLDPHWHU
Plunger
Plunger-cap
(blue) / (red)
%ODGHOHQJWKDGMXVWPHQWNQRE
Hole
CAUTION
<PHP33-CB09N-HS/PHP33-CB15N-HS>

Please fully insert the cutter blade straight into the plunger cap..
If the cutter blade cannot be inserted straight, please insert the cutter blade after pressing the insertion port of the cutter blade
several times.
Insertion port of the cutter blade
If not installed correctly, it may result in damage to the cutter blade or the plotter itself.
<PHP35-CB09-HS/PHP35-CB15-HS>

Please fully insert the cutter blade straight into the chuck.
If the cutter blade cannot be inserted straight, please insert the cutter blade after pressing the insertion port of the cutter blade
several times.
Insertion port of the cutter blade
If not installed correctly, it may result in damage to the cutter blade or the plotter itself.