GRAPHTEC FC9000-140 - Setting the Step Pass

7-8
7. 2
Setting the Step Pass
It may not cut the curved line smoothly if there is very short lines in the curve.
,WZLOOFXWLQWKHXQLWVRIWKHVSHFLÀHGYDOXHZKHQWKHSTEP PASS is used, which allows to control the short lines
with certain length, resulting to stable rotation of the blade for higher cut quality.
Setting range of STEP PASS is from 0 to 20.
$FWXDOOHQJWKRIWKH67(33$66LVWKHYDOXHRIWKH67(33$66PXOWLSOLHGE\WKHGLVWDQFHVHWLQWKH67(36,=(
Supplement

This setting will be saved even if the power is shut off.

The cut image may not be what you intended if the set value is too large. It is recommended to set to "1" for normal use.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
3
Press the [3] key (STEP PASS).
STEP PASS screen is displayed.
Supplement
You can set the range between 0 and 20.
4
Press the POSITION ( ) keys and increase or decrease
the setting value.