GRAPHTEC FC9000-140 - Priority of Tool Condition Selection (CONDITION PRIORITY)

11- 3
Priority of tool condition selection (CONDITION PRIORITY)
Select the priority of the setting created by different method when the tool condition is set.
All the tool condition that is received from the computer will be ignored, and only the setting and change of the
tool condition from the control panel is accepted when MANUAL is selected. This setting set here is maintained
even if the power is turned off.
On the other hand, it will set the most current tool condition either from the control panel or from the software
when PROGRAM is selected. The values set from the control panel are maintained, and the values set from the
software are erased when the power is turned off.
Operation
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
3
Press the POSITION ( ) key.
TOOLS SETTING screen (2/4) is displayed.
4
Press the [3] key (CONDITION PRIORITY).
CONDITION PRIORITY screen is displayed.
5
Press the [1] key (MANUAL) or the [2] key (PROGRAM).
6
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR722/66(77,1*VFUHHQ
(2/4).
7
Press the [PAUSE/MENU] key.
It will return to default screen.