GRAPHTEC FC9000-140 - Sorting the Cutting Data

8-2
8.1
Sorting the Cutting Data
When sorting cutting data, cutting is performed collectively so that the amount of movement in the media feed
GLUHFWLRQDQGWKHWRROUHSODFHPHQWWLPHDUHPLQLPL]HGVRFXWWLQJRSHUDWLRQLVLPSURYHGHIÀFLHQWO\
There are two types of sorting, area sort and tool sort.
Area sort : The cutting data is sorted so that the amount of movement in the media feed direction is
PLQLPL]HG,WLVPXFKPRUHHIÀFLHQWWKDQFXWWLQJDWLQWHUYDOVZLWKGDWDWKDWIRUFHVWRROVWRMXPS
from point to point.
7RROVRUW ,QRUGHUWRPLQLPL]HWKHWLPHLWWDNHVWRFKDQJHWKHWRROWKHRQHVZLWKWKHVDPHWRRO
conditions are plotted together.
Supplement

Sorting will start the process after all the data are stored in the buffer memory, so it takes time to start the cutting.

6RUWLQJPLJKWQRWEHHIIHFWLYHIRUWKHGDWDWKDWLVFUHDWHGHIÀFLHQWO\

Process may be faster to turn off the sorting on the plotter, if the data is already sorted using the software on the PC.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
3
Press the POSITION ( ) key.
TOOLS SETTING screen (2/4) is displayed.