GRAPHTEC FC9000-140 - Chapter 8: Settings Regarding Cutting Time

8-1
Chapter 8:
Settings Regarding Cutting Time
7LPHQHFHVVDU\IRUFXWWLQJGHSHQGVRQWKHVSHHGWRPRYHWKHWRRODQGPHGLDDQGHIÀFLHQF\RIWKH
operation.
It is best to cut slowly and carefully to cut precisely, but the speed is required to enhance the operational
HIÀFLHQF\7KHVHWWLQJQHHGVWREHLQJRRGEDODQFHFRQVLGHULQJWKHFKDUDFWHULVWLFVRIWKHPHGLDDQGWRROV
and the contents of the cutting data.
This chapter describes the settings affecting the cutting time.
In addition to this chapter, there are settings affecting the cutting times in following places.
PRODUCT SUMMARY
8.1 Sorting the Cutting Data
8.2 Perform Automatic Pre Feed When Cut Data is
Received
8.3 Perform Automatic Pre Feed When Media is Set
(Initial Feed)
8.4 Setting Feed Speed for Pre Feed
8.5 Setting the MOVING SPEED
8.6 Setting the Tool Up Move
8.7 Setting the Tool Up Height