GRAPHTEC FC9000-140 - Printing the Setting of the Plotter

16-16
16.2
Printing the Setting of the Plotter
Condition setting list can be printed when you need to check the current setting of the plotter.
CAUTION

'RQRWSODFH\RXKDQGDURXQGWKHPRYLQJDUHDV7KHWRROFDUULDJHZLOOVWDUWPRYLQJVRWKHUHLVDULVNRILQMXU\7RROFDUULDJHZLOOVWDUW
to move immediately after selecting to print the CONDITION list.

Once you start printing, pause/cancel cannot be performed in the middle.
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
for loading the media.
1
/RDGDPHGLDODUJHUWKDQ$VL]H
Supplement

See "Attaching a Tool" for setting the pen tool.

For changing the tool conditions please refer
to "Selecting Tool Condition", and for tool
settings please refer to "Setting the Tool".
2
Set the pen tool to the tool holder (Backward) and select the
condition where the pen tool is set.
3
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4
Press the POSITION ( ) key (TEST).
TEST screen (1/2) is displayed.
5
Press the [1] key (CONDITION LIST).
CONDITION LIST PRINT screen is displayed.