GRAPHTEC FC9000-140 - Connecting to the Computer

1-7
1.4
Connecting to the Computer
Connect the plotter to the computer using the interface cable. Use one of the USB ports, the network (LAN)
LQWHUIDFHRUWKH56&SRUWWRFRQQHFWWKHSORWWHUWRWKHFRPSXWHU6HOHFWWKHSRUWGHSHQGLQJRQWKHVSHFLÀFDWLRQ
of the software to be used and the availability of the interface port on the computer.
Please install driver software before connecting.
Depending on the port used, use one of the USB cable (standard accessories), the network (LAN) cable
(commercially available product) or the RS-232C cable (commercially available product) to connect. Use the
FDEOHVVSHFLÀHGE\*UDSKWHFPDWFKLQJWKHFRPSXWHUWKDWLVWREHFRQQHFWHG
This will be explained in FC9000-140.
* RS-232C interface depends on the sales area. For details, please contact the distributor where you purchased.
Connection
1
Check that the power switch is turned off (the " " side is
pressed down).
Supplement
See the "Setting Interface" for setting the
interface.
2
Connect the plotter to the computer using the interface cable.
Connection via USB interface
USB cable
(accessories)
Computer