GRAPHTEC FC9000-140 - Error Messages in HP-GL Command Mode

16-7
Error Messages in HP-GL Command Mode
If any of the following command errors occur, they are nearly always caused by following 2 reasons.
7KHFRQÀJXUDWLRQUHJDUGLQJWKHRXWSXWGHYLFHLQWKHDSSOLFDWLRQVRIWZDUHKDVFKDQJHG
2. The plotter's interface conditions have changed.
Perform following if these are the cause of the problem.
5HFRQÀJXUHWKHRXWSXWGHYLFHRIWKHDSSOLFDWLRQVRIWZDUHWRWKHSORWWHU
5HFRQÀJXUHWKHSORWWHUVLQWHUIDFHFRQGLWLRQV
Error
Displayed
LCD Display Cause Solution
E03001
Error 1
$QXQUHFRJQL]DEOHLQVWUXFWLRQZDV
executed.
([HFXWHDUHFRJQL]DEOHFRPPDQG
E03002
Error 2
Wrong number of parameters were
VSHFLÀHG
Execute the command with the correct
number of parameters.
E03003
Error 3
An unusable parameter was executed. ([HFXWHDUHFRJQL]DEOHSDUDPHWHU
E03005
Error 5
$QXQXVDEOHFKDUDFWHUVHWZDVVSHFLÀHG Specify usable character set.
E03006
Error 6
&RRUGLQDWHVRIFRPPDQGVSHFLÀHGRXWRI
cutting area.
Execute coordinates within the cutting area.
E03007
Error 7
The data being input exceeds the capacity
of the plotter's downloadable character
buffer, polygon buffer, etc.
$GMXVWWKHEXIIHUVL]H
E03010
Error 10
Other output command was executed while
executing an output command.
Check the program.
E03011
Error 11
An invalid byte was received after ESC
code.
Check the program.
E03012
Error 12
Invalid byte was received within device
control command.
Check the program.