GRAPHTEC FC9000-140 - Set Cross Cut between Registration Marks

5-27
Set cross cut between registration marks
When data is output in the media feed direction, set whether to cross-cut between registration marks.
Set cross cut when you want to cross-cut between registration marks in the media feed direction.
Supplement
Leave a gap of at least 20 mm between the registration marks.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/3) is displayed.
3
Press the POSITION ( ) key.
ARMS SETTING screen (3/3) is displayed.
Supplement
It will return to ARMS SETTING screen (3/3)
without changing the settings when you press
the [ESC] key (CANCEL).
4
Press the [1] key (ARMS CROSSCUT).
ARMS CROSSCUT screen is displayed.
5
Press the [1] key (ON) or the [2] key (OFF).