GRAPHTEC FC9000-140 - Pouncing (Punch Continuous Holes); Attaching the Pouncing Tool

17-2
17.1
Pouncing (Punch Continuous Holes)
Pouncing is a method used to create a punched outline on media.
Attaching the Pouncing Tool
Mounting
1
Loosen the tool holder screw.
Tool holderBracket to hold tool
Bracket to hold tool
Tool holder
Top
Supplement
Attach the pouncing tool to the half cutting
(backward) side. It may damage the panel if it is
attached to the forward side.
Tool holder
(Backward: Half cutting)
Tool holder
(Forward: Using cutting)
Top
2
While pushing the tool holder in the upward direction, push
WKH3RXQFLQJWRRODOOWKHZD\LQWRWKHKROGHUXQWLOLWVÁDQJH
FRQWDFWVWKHXSSHUSDUWRIWKHKROGHU7KHÁDWHGJHPXVWEH
parallel to the tool holder.
In parallel
Flange
Top of bracket to hold tool
Flat edge