GRAPHTEC FC9000-140 - Between Tools 1 and 2

7-25
Between tools 1 and 2
(Option 2-pen type only)
If there is a misalignment in the cutting/plotting between Tool 1 (tool attached to the backward of the tool holder)
DQG7RROWRRODWWDFKHGWRWKHIRUZDUGRIWKHWRROKROGHU\RXFDQFRUUHFWLWE\HQWHULQJWKHDGMXVWPHQWYDOXH
Supplement
Set "TOOL NO. SETTING" of tool condition 1 to 1 and set "TOOL" to Cutter.
Set "TOOL NO. SETTING" of tool condition 2 to 2 and set "TOOL" to Pen.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOL SETTING (1/4) screen is displayed.
3
Press the [2] key (TOOL OFFSET ADJ.).
TOOL OFFSET ADJ. screen is displayed.
4
Press the [1] key (TOOL 1-3).
TOOL OFFSET ADJ. screen is displayed.