GRAPHTEC FC9000-140 - Replacing the Cross Cut Unit

15-11
15.6
Replacing the Cross Cut Unit
Replace the cross cut unit used to cut off the media after cutting.
Supplement
Please replace the cross cut unit according to the guidelines below.

3DSHUEDFNÀOPPPZLGWKPHGLDDSSUR[VKHHWV0RGHO30&&

3ODVWLFEDFNÀOPPPZLGWKPHGLDDSSUR[VKHHWV0RGHO30&&
Operation
1
Check that the power switch is turned off. (the " " side is
pressed down)
CAUTION
The cross cut unit uses a very sharp blade.
Take care not to cut yourself on the blade.
2
Remove the screw holding the cross cut unit in place, and
then remove the cross cut unit.
Cross cut unit