GRAPHTEC FC9000-140 - Setting the Tool

2-34
Setting the tool
Set the type and offset value of the tool that is used.
Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
Press the [1] key to change the CONDITION No.
It will return to CONDITION setting screen
without changing the settings when you press
the [ESC] key (CANCEL).
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.
3
Press the POSITION ( ) keys and set the tool.
Supplement

What is Offset
,WZLOODGMXVWWKHGLIIHUHQFHEHWZHHQWKHWLS
of the blade in the plunger and the center of
WKHSOXQJHU7KHUHDUHVWDQGDUGDGMXVWPHQW
values for each cutter blades.
)LQHDGMXVWPHQWZLOOEHPDGHWRWKDWVWDQGDUG
YDOXHVKHUH$GMXVWPHQWZLOOEHPDGHZLWK
standard value as 0.)
It is not necessary to set the offset if "PEN",
was selected in the tool settings. (not
displayed)

Guideline to Set Offset
See the Cutter Blade Manual

You can set the range between -5 and +5.
The other range is +1 to +45.

To continue the settings of other tool condition
number, return to step 3 by pressing the [1]
key.
4
Press the [3] key (OFFSET).
OFFSET setting screen is displayed.