GRAPHTEC FC9000-140 - When Media Change Mode Is on

4-13
When media change mode is ON
The Change Media message appears each time when ending a single cut in Media Change mode.
Choosing to change media will instantly detect the media and proceed to a copy area (cut).
Media switch copies can be made up to the set copy number (designated number).
Operation
1
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
Supplement

Turning MEDIA CHANGE MODE on will
display the CHANGE MEDIA message each
time after a single cut.
"If the [ESC] key (QUIT COPY) is pressed,
copying will be suspended and it will return to
the default screen.

When exchanging media, the media selection
will be chosen from what was selected
before copying.

If there is no data in the buffer memory,
12'$7$)25&23<,1%8))(5ZLOOEH
displayed. Please send cutting data.

If too much data is sent from the buffer
PHPRU\&23<02'(%8))(5)8//ZLOO
be displayed.
2
Press the [COPY] key.
COPY MODE screen is displayed.
3
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE screen is displayed.
Supplement
It will return to COPY MODE screen without
changing the settings when you press the [ESC]
key (PREVIOUS).
4
Press the [2] key (ON).
&RQÀUPWKHVHWWLQJVDQGLWZLOOUHWXUQWRWKH&23<02'(VFUHHQ
Supplement
The copy number can be set from 1 to 100.
5
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
6
Press the POSITION ( ) keys and increase or decrease the
setting value.