4-12
6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES screen is displayed.
Supplement
Number of copies can be set as much as it
FDQÀWLQWKHPHGLDVHWRQWKHSULQWHU
The initial value for the number of copies is
always 1.
7
Press the POSITION ( ) keys and increase or decrease the
setting value.
Supplement
&$1127&23<&87$5($72260$//LV
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
8
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
Number of copies will be selected, and it will return to COPY MODE
screen.
Supplement
COPY MODE SETTINGS can be set when
MEDIA CHANGE MODE is turned OFF.
COPY SPACE can be set from 1.0 mm to
50.0 mm.
CROSS CUT SPACING can be set when
CROSS CUT is turned ON.
This setting is maintained even if the power is
turned off.
9
Press the [3] key (COPY MODE SETTINGS).
COPY MODE SETTINGS screen is displayed.
10
Press the POSITION ( ) keys to increase or decrease the
current setting for [1] key (COPY SPACE X), [2] key (COPY
SPACE Y) and [4] key (CROSS CUT SPACING).
[3] key (CROSS CUT) can be set by pressing the [1] key (OFF)
or the [2] key (ON).
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.
11
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
"COPY" is displayed on the screen, and it will copy as much as
VSHFLÀHG
To Next Page
Loading...
