GRAPHTEC FC9000-140 - Page 101

4-11
It will copy in following order when ROTATE is set.
Origin point
First cut
Copy origin point
Fifth copy
First copy
Copy
space
Copy
space
Sixth copy
Third copy
Fourth copy
Second
copy
Operation
1
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
2
Press the POSITION ( ) keys and move the tool
carriage to the position to copy.
Supplement

When setting the copy interval, set "MEDIA
CHANGE MODE" to OFF.

12'$7$)25&23<,1%8))(5LV
displayed if there is no data in the buffer
memory. Send the cutting data.

If too much data is sent from the buffer
PHPRU\&23<02'(%8))(5)8//ZLOO
be displayed.

If the data to be copied is larger than the
cutting area, "CANNOT COPY CUT AREA
72260$//ZLOOEHGLVSOD\HG
3
Press the [COPY] key
COPY MODE screen is displayed.
4
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE screen is displayed.
5
Press the [1] key (OFF).
Confirm the settings and it will return to the COPY MODE screen.