GRAPHTEC FC9000-140 - Moving the Pen While Raised or Lowered in Response to the W Command (COMMAND W)

11- 6
Moving the pen while raised or lowered in Response to the 'W' command (COMMAND 'W')
Here, you can change the settings for the 'W' command, which is a GP-GL arc cutting command.
This function set the operation upon receipt of the 'W' command for the drawing of arcs.
7KHSHQZLOOPRYHWRWKHVSHFLÀHGVWDUWLQJSRVLWLRQLQWKHUDLVHGVWDWXVZKHQLWLVVHWWR722/83UHJDUGOHVVRI
WKHSHQ·VFRQGLWLRQV7KHSHQZLOOPRYHZLWKRXWFKDQJLQJLWVFRQGLWLRQWRWKHVSHFLÀHGVWDUWLQJSRVLWLRQLQWKH
lowered status when it is set to TOOL DOWN.
Supplement
This has an effect on the tool cutter only. For the pen setting, always the pen is raised (PEN UP).
Operation
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/3) is displayed.
3
Press the POSITION ( ) key.
INTERFACE screen (3/3) is displayed.
4
Press the [1] key (COMMAND 'W').
COMMAND 'W' screen is displayed.
5
Press the [1] key (TOOL DOWN) or the [2] key (TOOL UP).
6
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR,17(5)$&(VFUHHQ
7
Press the [PAUSE/MENU] key.
It will return to default screen.