GRAPHTEC FC9000-140 - Running Cutting Tests; Cutting Test

13-19
13.9
Running Cutting Tests
Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results. Check how far the blade cuts into the
PHGLDDQGKRZWKHFRUQHUVDUHEHLQJFXW,IWKHFXWWLQJUHVXOWVDUHQRWVDWLVIDFWRU\DGMXVWWKHYDULRXVVHWWLQJVDQG
repeat the test cutting until the optimal settings are achieved.
Cutting test
Here, you can cut the test pattern based on the current values.
Operation
1
Load the media you want to actually cut.
2
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION setting screen
without changing the settings when you press
the [ESC] key (CANCEL).
3
Press the POSITION (
) key (CUT TEST).
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
4
Press the POSITION ( ) keys to move the tool carriage
to the position where the TEST CUT is performed.
CAUTION
When the [ENTER] key is pressed, the tool
carriage will start moving, so take care not to get
LQMXUHGE\WKHFXWWHUEODGH
5
Press the [ENTER] key.
TEST CUT PATTERN is cut.