GRAPHTEC FC9000-140 - Blade Application and Features

2-4
Adjusting the blade length
%ODGHOHQJWKQHHGVWREHDGMXVWHGWRSHUIRUPRSWLPDOFXW3HUIRUPIHZWHVWFXWVDQGVHWWKHRSWLPDOEODGHOHQJWK
CAUTION

7RDYRLGERGLO\LQMXU\KDQGOHFXWWHUEODGHVZLWKFDUH

It may result in damaging the cutter blade or the cutting mat if the blade is extended too much. Make sure the blade length is set less
than the thickness of the media.
 $IWHUDGMXVWPHQWSOHDVHDOZD\VSHUIRUPWHVWFXW
Supplement

See "Running Cutting Tests" for cutting tests.

,IDWKLQPHGLDVXFKDVDÀOPLVXVHGXVHWKHVXSSOLHGPDJQLÀHUWRDGMXVWLW
$GMXVWWKHEODGHOHQJWKE\WXUQLQJWKHEODGHOHQJWKDGMXVWPHQWNQRE7XUQWKHNQRELQGLUHFWLRQ$WRH[WHQG
the blade, or in direction "B" to retract the blade. When the knob is turned by one scale unit, the blade moves
approximately 0.1 mm. One full turn of the knob moves the blade approximately 0.5 mm.
Cutter blade moves
approximately 0.1 mm turning
one scale unit
Scale
Scale
PHP33-CB09N-HS/PHP33-CB15N-HS
Cutter blade moves
approximately 0.1 mm turning
one scale unit
Scale
Scale
PHP35-CB09-HS/PHP35-CB15-HS
Blade application and features
Select the optimal cutter blade and medium to be cut.
Refer to the Cutter Blade Manual.
CAUTION
7RDYRLGERGLO\LQMXU\KDQGOHFXWWHUEODGHVZLWKFDUH