GRAPHTEC FC9000-140 - I;F (Lan); Setting the DHCP

9-5
9.3
I/F (LAN)
Set the network interface (LAN).
Supplement
When you change the settings of the network, the plotter is reset.
To connect through a network (LAN), it is necessary to set the following items.

Set the DHCP

Set the IP address

Set the subnet mask

Set the gateway

Display the MAC address
Setting the DHCP
'+&3VHWWLQJVGHSHQGRQWKHFRQÀJXUDWLRQRIQHWZRUNHTXLSPHQWDQGWKHFXVWRPHU·VHQYLURQPHQW)RUGHWDLOV
please see the equipment manual, or consult the network administrator.
The default setting of DHCP is OFF.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/3) is displayed.