18-19
18.4
Troubleshooting (take -up)
This section describes how to clear troubles.
Take-up operation is not performed
Possible Cause Solution Reference
There is no power supplied. Make sure that the take-up roller cable or
take-up sensor cable is properly connected
to the connector on the cutting plotter.
"Assembling Manual" of TAKE-UP unit
Sensor is not responding. Make sure that the sensor unit is
not blocked by media or a basket.
Alternatively, check that the take-up
sensor cable is properly connected to
the connector on the cutting plotter.
"Assembling Manual" of TAKE-UP unit
The TAKE-UP is not set to ON. Make sure that the TAKE-UP is set to
ON.
Setting the take-up function
Machine failure. Contact your sales representative or the
Graphtec customer center if the problem
still exists.
Media take-up is skewed
Possible Cause Solution Reference
Push rollers are not set properly on the
grit rollers.
Check the position of the push roller. /RDGDPHGLDSDSHURUPDUNLQJÀOP
Changing of the hold-down force of the
push roller is not suitable for the media.
Please set a media suitable for changing
the hold-down force.
Hold-down force
Roll media or paper core for take-up is
not set properly.
Set roll media or paper core for take-up
properly.
Preparing to Cut (Take-up)
The stocker and the stoppers of media
guide are not secured.
Secure the stockers and the stoppers of
media guide.
Preparing to Cut (Take-up)
The path of media to be taken up is not
properly set.
Set the path of media to be taken up. Preparing to Cut (Take-up)
Abnormal noise occurs during operation of the take-up roller
Possible Cause Solution Reference
The roller lock plate is not secured. 6HFXUHWKHUROOHUORFNSODWHÀUPO\ "Assembling Manual" of TAKE-UP unit.
Machine failure. Contact your sales representative or the
Graphtec customer center if the problem
still exists.
www.delinit.by
To Next Page
Loading...
