GRAPHTEC FC9000-140 - Assignment

2-19
Assignment
The hold-down force of push rollers on both ends (left/right) should set to the same force in Strong or Medium.
However, when using three or more push rollers, set the hold-down force of the push rollers inside both ends to
lower than both ends.
Strong
Strong Strong
Strong Medium
Medium Medium Low Low Low Low
Medium
When using two push rollers
GOOD
NG
When right and left
hold-down forces are
different
Strong StrongMedium Medium Medium Medium Medium MediumLow
When using three push rollers
GOOD
NG
When three hold-down
forces are different
All other than above
Strong StrongMedium
Medium
Medium Medium Medium Medium Medium
MediumLow Low
When using four push rollers
GOOD
NG
When three hold-down
forces are different
All other than above