GRAPHTEC FC9000-140 - Automatic Detection of Registration Mark Position; Media that Registration Mark Cannot be Detected

5-7
Automatic detection of registration mark position
The registration mark is detected within area A from the registration mark scanning start position (tool position).
When the registration mark is not detected within the area A, then within area B is detected. Only when the
UHJLVWUDWLRQPDUNLVSUHVHQWLQDUHD$RU%LWLVSRVVLEOHWRUHFRJQL]HDVWKHPDUN
Unit: approx. mm
Feed direction of media
100100
100100
Registration mark
reading start
position
Media that registration mark cannot be detected
It may be hard to scan the registration mark as following, depending on the media conditions.

Transparent media

Lines of registration marks are blurred

Media that does not become an expected color due to the color of the background after printing

Folded media

Surface is dirty

Laminated media (Depending on the type and condition of the laminate)
If you use media that does not have registration marks printed in black on white background, set the automatic
detection of registration mark position to OFF. (See "Setting registration mark automatic detection")
In addition, set the MARK SCAN Mode. (See "Setting MARK SCAN Mode".)