GRAPHTEC FC9000-140 - Low Movement Speed Setting by POSITION Key (POSI. KEY SPEED + SLOW KEY)

10-9
Low Movement Speed Setting by POSITION key (POSI. KEY SPEED + SLOW KEY)
Press the POSITION ( ) key and the [SLOW] key simultaneously to set the movement speed when moving
the tool carriage.
Operation
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION ( ) key (ADV.).
ADVANCE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
ADVANCE screen (2/4) is displayed.
4
Press the [1] key (POSI. KEY SPEED + SLOW KEY).
POSI. KEY SPEED + SLOW KEY setting screen is displayed.
Supplement
You can set the range between 1 and 15 (cm/s).
5
Press the POSITION ( ) keys and increase or decrease the
setting value.
Supplement
It will return to ADVANCE screen (2/4) without
changing the settings when you press the [ESC]
key (CANCEL).
6
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
Setting will be confirmed and it will return to ADVANCE screen (2/4).
7
Press the [PAUSE/MENU] key.
It will return to default screen.