GRAPHTEC FC9000-140 - Page 174

7-24
Supplement
You can set the range between -3.0 mm and
+3.0 mm.
9
Press the POSITION ( ) keys and increase or decrease the
setting value.
10
 &RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
7RRO,QWHUYDO$GMXVWPHQWVFUHHQLVGLVSOD\HG
11
Press the [4] key (Y=+0.0mm).
7RRO,QWHUYDO$GMXVWPHQW<VFUHHQLVGLVSOD\HG
Supplement
You can set the range between -3.0 mm and
+3.0 mm.
12
Press the POSITION ( ) keys and increase or decrease the
setting value.
13
 &RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
TOOL OFFSET ADJ. screen is displayed.
14
Repeat steps 4 to 13 until the misalignment between the two
tools is corrected.
Supplement
It will return to TOOLS SETTING screen (1/4)
without changing the settings when you press
the [ESC] key (CANCEL).
15
 &RQÀUPWKHLQWHUYDODQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR722/6(77,1*
screen.
16
Press the [PAUSE/MENU] key.
It will return to default screen.