GRAPHTEC FC9000-140 - Page 127

5-13
6
&RQÀUPWKHSRVLWLRQRIWRRODQGSUHVVWKH>(17(5@NH\6(7
Supplement
In the case of "not good", check the following.

Check if the registration mark type is correct.

&KHFNLIWKH6&$10RGHDQGDGMXVWPHQW
value are correct.

Check the recommended value setting again.

Make the registration mark line thicker.

Check the above-mentioned "Media That
Registration Mark Cannot be Detected".
Even if the above is done, if it is "not good", the
registration mark cannot be used.
7
The scanning result is displayed on the screen.
SCAN MODE : The currently set scanning mode is displayed.
RESULT: The scanning result (OK / NG) is displayed.
8
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\&$1&(/
It will return to ARMS SETTING screen (1/3).
9
Press the [PAUSE/MENU] key.
It will return to default screen.