GRAPHTEC FC9000-140 - Page 134

5-20
Detect the registration mark for adjustment on the media and enter the value
0HWKRGWRHQWHUWKHDGMXVWPHQWYDOXHZKLFKLVWKHGLIIHUHQFHEHWZHHQWKHVFDQQHGUHJLVWUDWLRQPDUNRQWKH
media and the cutting position, is described here.
Supplement
3ORWWKHUHJLVWUDWLRQPDUNEHIRUHJRLQJWRIROORZLQJVWHSVLIWKHUHLVQRUHJLVWUDWLRQPDUNGUDZQRQWKHPHGLD6HH$GMXVW$IWHU3ORWWLQJ
WKH$GMXVWPHQW5HJLVWUDWLRQ0DUNWRSORWUHJLVWUDWLRQPDUNV
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
for loading the media.
1
/RDGWKHPHGLDZLWKDGMXVWPHQWUHJLVWUDWLRQPDUNLQWKH
plotter.
2
Press the [PAUSE/MENU] key.
MENU screen is displayed.
3
Press the [2] key (ARMS).
ARMS SETTING screen (1/3) is displayed.
4
Press the POSITION ( ) key.
ARMS SETTING screen (2/3) is displayed.
Supplement
It will return to ARMS SETTING screen (3/4)
without changing the settings when you press
the [ESC] key (CANCEL).
5
Press the [1] key (SENSOR OFFSET ADJ.).
SENSOR OFFSET ADJ. screen is displayed.