GRAPHTEC FC9000-140 - Page 15

C-5
9.3 I/F (LAN) ...........................................................9-5
Setting the DHCP .......................................................9-5
Set IP address, subnet mask, gateway ......................................9-7
9.4 Connecting with RS-232C .............................................9-10
Switching the setting number you want to use ................................9-10
Changing/storing the RS-232C setting ......................................9-11
Chapter 10: Settings Regarding Operation Environment
10-1 Related to menu display ..............................................10 -2
Display language setting (LANGUAGE SELECTION) ..........................10 - 2
Display Length Unit Setting (LENGTH UNIT) .................................10 - 3
10-2 Related to sensor ...................................................10 - 4
Enabling/Disabling the media sensors (MEDIA SENSOR) ......................10 - 4
Enabling/Disabling the push roller sensors (PUSH ROLLER SENSOR) ............10 - 5
10-3 Related to plotter environment .........................................10 -7
Fan suction setting (FAN POWER) .........................................10 -7
Enabling/Disabling the beep setting (BEEP FOR KEY OPERATION) ..............10 -8
Low Movement Speed Setting by POSITION key (POSI. KEY SPEED + SLOW KEY) .10 - 9
High Movement Speed Setting by POSITION key (POSI. KEY SPEED) ...........10 -10
Pause key select setting (PAUSE/MENU KEY SETTING) ......................10 -11
LCD contrast setting (LCD CONTRAST) ...................................10 -12
Chapter 11: Settings of Controls from Computer
11-1 Related to command processing ........................................ 11- 2
Setting the command (COMMAND) ........................................11- 2
Priority of tool condition selection (CONDITION PRIORITY) .....................11- 3
11-2 Related to GP-GL command ........................................... 11- 4
6HWWLQJWKHVWHSVL]H*3*/67(36,=( ...................................11- 4
Enabling/Disabling the ' : ' and ' ; ' commands (COMMAND ' : ', ' ; ') ...............11- 5
Moving the pen while raised or lowered in
Response to the 'W' command (COMMAND 'W') .............................
11- 6
11-3 Related to HP-GL command ............................................11-7
Model ID response (HP-GL MODEL EMULATED) ............................. 11-7
Circle-command resolution setting (CIRCLE RESOLUTION) ....................11- 8
Chapter 12: Data Link
12.1 Select Connection Destination .........................................12- 2
12.2 Data Link with USB Memory ...........................................12- 3
12.3 Output with a BarCode ...............................................12- 5
12.4 Start Mark Auto Scan ................................................12- 8
12.5 Communication Timeout .............................................12-10
12.6 Skew Scanning ....................................................12-12
Chapter 13: Apparel (AP) Mode
13.1 Apparel (AP) Mode ..................................................13-2
 2YHUYLHZRI$[LV$GMXVWPHQW ..........................................13 - 4
Alignment mark ..........................................................13 - 4