GRAPHTEC FC9000-140 - Page 155

7-5
7
Press the [2] key (START).
START screen is displayed.
Supplement
You can set the range between 0.0 mm and 0.9
mm.
8
Press the POSITION ( ) keys and increase or decrease
the setting value.
9
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
Length for overcut START is selected and return to OVERCUT setting
screen.
10
Press the [3] key (END).
Overcut length for END setting screen is displayed.
Supplement
You can set the range between 0.0 mm and 0.9
mm.
11
Press the POSITION ( ) keys and increase or decrease
the setting value.
12
 &RQÀUPWKHVHWWLQJDQGSUHVVWKH>(6&@NH\35(9,286
Length for overcut END will be selected and it will return to OVERCUT
screen.
13
Repeat steps 3 to 12 as necessary to set multiple tool
CONDITION No.
Supplement
It will return to CONDITION setting screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
14
 &RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR&21',7,21VHWWLQJVFUHHQ
(2/3).
15
Press the [COND/TEST] key.
It will return to default screen.