GRAPHTEC FC9000-140 - Page 293

14-19
3
When "Save As" screen is displayed, specify "USB
PHPRU\WRVDYHWKH;3)ÀOH
* You can save it to an arbitrary folder and then move it to
USB memory.
When using Cutting Master 4
1
In Adobe Illustrator, select "Cutting Master 4" - "Cut/Plot"
from the File menu.
In CorelDRAW, select "Launch" - "Cut/Plot (CM4)" from
the tool bar.
* If using CorelDRAW version X7 or earlier, select from
the application launcher.
Before selecting the Cut/Plot, set the layer of printing
data to Hide .
Supplement
When the "Cut Contour" screen is displayed
IRUWKHÀUVWWLPHWKH$GG'HYLFHVFUHHQLV
displayed. Follow the instructions on the screen
to select the model name to use.

For USB connection, select the "Graphtec
USB".

For network connection, select the "TCP/IP"
and then enter the IP address of the cutting
plotter.
2
The "Cut/Plot" screen is displayed.
3UHVVWKH6DYHWRÀOH
3
When "Save As" screen is displayed, specify "USB
PHPRU\DQGVDYHWKH;3)ÀOH
* You can move to USB memory after saving in any folder.