14-26
When using Cutting Master 4
1
In Adobe Illustrator, select "Cutting Master 4" -
"Registration Marks" from the File menu.
In CorelDRAW, select "Launch" - "Registration Marks
(CM4)" from the tool bar.
Set type, thickness and length of registration mark.
Check the "Use Barcode".
Select the "Roll Media" from the "Barcode Type".
The margins of the printer driver selected in the
DSSOLFDWLRQDUHLQLWLDOL]HGLQ3ULQWHU0DUJLQ:KHQ
changing the printer, acquire margin information by
pressing the "Get Printer Margins".
Press the “OK”.
* If selecting from the application launcher in CorelDRAW
version X7 or earlier and, the Registration Marks screen
will be displayed.
* The following screen is the screen when starting from
Adobe Illustrator.
Supplement
Registration marks are placed automatically.
The position cannot be changed.
2
Registration marks and barcode are created on the design
screen.
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Barcode Barcode
To Next Page
Loading...
