GRAPHTEC FC9000-140 - Page 305

14-31
Step 5: Start data link server.
6WDUWWKHGDWDOLQNVHUYHUWRVHQGMREÀOHLQIRUPDWLRQWRWKHFXWWLQJSORWWHU
Operation
5-
1 Start the data link server.
When using Graphtec Pro Studio
Supplement

The cutting plotter supports only one data
link server. Connecting two or more data link
servers to a single cutting plotter may not
work properly.

When using the data link server, do not use
USB connection and network connection at
the same time. Connect to the interface only
that uses the data link server.

When using a data link server with network
connection, always connect with a LAN cable.
When connecting with wireless (Wi-Fi), it may
not operate properly.
1
Click on the "Data Link" icon.
2
Each time the icon is clicked, start/stop of the datalink
server is switched.
In the start state, a red frame is displayed around the
icon.
Start Stop