18-12
4
Cut the loaded roll media (or media of the same width) to
about 1.2 m and prepare the support media. Make the cutting
end face as straight as possible.
90°
90°
90°
90°
Same width as loaded roll media
&XWVWUDLJKWKRUL]RQWDOO\
Approx. 1.2 m
Feed direction of media
5
Paste a support media straight and evenly to the paper core
for take-up.
Pass the pasted support media between the take-up roller
(drive) and the center bar.
* If the support media is not pasted straight, it may cause
take-up problems.
* Please change the pasting place according to the length of
the media.
Tape
Support media
7UDMHFWRU\RIVXSSRUWPHGLD
Center bar
To Next Page
Loading...
