GRAPHTEC FC9000-140 - Page 399

I-3
Setting Cut Line Pattern ....................... 7-15
Setting cutting area ............................ 4-2
Setting cutting width ........................... 4-4
Setting Feeding Method ....................... 2-27
6HWWLQJ,QLWLDO%ODGH&RQWURO3RVLWLRQ$GMXVW ........ 7-19
Setting length of the page ....................... 4-5
Setting mirror ................................. 4-7
Setting of the Initial Down Force .................. 7-6
Setting origin point when HP-GL is set ............. 3-9
Setting Paper Exposure Time .................. 13-28
Setting Rear Margin ......................... 13-24
Settings for Cutting ............................ 4-2
Setting speed of the registration mark scan ........ 5-25
Setting step movement distance .................. 3-4
Setting the acceleration ....................... 2-38
Setting the command ......................... 11-2
Setting the Cutting Direction .................... 3-10
Setting the DHCP ............................. 9-5
Setting the force ............................. 2-37
Setting the length of overcut ..................... 7-4
Setting the Number of Pre Feeds ............... 13-26
Setting the OFFSET FORCE ................... 7-21
Setting the Origin Point ......................... 3-7
Setting the speed ............................ 2-36
6HWWLQJWKHVWHSVL]H .......................... 11- 4
Setting the tangential mode ..................... 7-3
Setting the tool .............................. 2-34
Setting the tool condition ...................... 2-32
Setting tool No. .............................. 2-40
SETUP MANUAL ............................. 1-2
Sheet media ................................ 2-13
Skew Scanning ............................. 12-12
SLOW ..................................... 2-23
Software Activation Code ....................... 1-2
Sorting ...................................... 8-2
Stand ....................................... 1-5
Start Mark Auto Scan ......................... 12-8
STEP PASS .................................. 7-8
Stock shaft .................................. 1-5
Stop Cutting ................................ 3-12
Stopper ..................................... 1-5
Subnet mask ................................. 9-7
Supplies ..................................... A-3
T
Take-up roller ............................... 18-4
Take-up sensor unit ........................... 18-4
Tangential mode .............................. 7-2
TEST ...................................... 2-25
Test pattern ................................ 16-20
Test Pattern ................................ 16-18
Test the registration mark sensor ................ 5-14
TO ENSURE SAFE AND CORRECT USE Cutter. . . . . 1-2
TOOL ...................................... 2-25
Tool carriage ................................. 1-4
Tool holder ........................... 1-4, 2-5, 17-5
TOOL UP HEIGHT ........................... 8-13
Tool up movement ............................ 8-11
U
UP MODE .................................. 7-15
USB cable ................................... 1-2
USB interface ................................ 9-2
USB interface connector ........................ 1-5
USB memory dedicated connector ................ 1-5
User Switching .............................. 4-23
W
:DWHUEDVHGÀEHUSHQ .......................... 1-2
:DWHUEDVHGÀEHUSHQDGDSWHU ................... 1-2
When media change mode is OFF ............... 4-10
When Media Change Mode is OFF and
Cross Cut is ON. .............................
4-15
When media change mode is ON ................ 4-13