GRAPHTEC FC9000-140 - Page 71

2-45
9
Press the [ESC] key (CANCEL).
It will return to CONDITION setting screen.
10
Press the [COND/TEST] key.
It will return to default screen.
&RQÀUPWKHUHVXOWVRIWKHFXWWLQJWHVW
&RQÀUPWKHFXWWLQJWHVWUHVXOWVDQGDGMXVWWRRSWLPDOVHWWLQJ5HSHDWFXWWLQJWHVWDQGDGMXVWPHQWXQWLORSWLPDOFXW
is achieved.
Adjustment of Offset
Supplement
How to check offset
Check if the offset value is set correctly by
following.
  1RWHQRXJKDGMXVWPHQW
Increase the offset value.
Optimal offset value.
  7RRPXFKDGMXVWPHQW
Decrease the offset value.
Check the corners of the triangles and rectangles. See "Setting the
7RRO&RQGLWLRQDQGDGMXVWWKHRIIVHWYDOXHLIWKHFRUQHULVQRWFXWRU
if it is cut too much.
$GMXVWWKHRIIVHWYDOXH
Adjustment for Half Cutting
Supplement
6HH$GMXVWLQJWKH%ODGH/HQJWKDQG6HWWLQJ
WKH)RUFHDQGDGMXVWWKHVHWWLQJV
3HHORIIWKHWULDQJOHDUHDDQGDGMXVWVRLWFXWVVOLJKWO\LQWRWKH
backing sheet.
If the backing sheet has been cut through, either the FORCE setting
is too high or the cutter-blade tip is extended too far. If the backing
sheet shows only a few traces of the cutter blade, either the FORCE
VHWWLQJLVWRRORZRUWKHFXWWHUEODGHWLSLVQRWVXIÀFLHQWO\H[WHQGHG
Adjustment for cutting out
$GMXVWVRWKHPHGLDLVFRPSOHWHO\FXWRXW
,IWKHPHGLDLVQRWFRPSOHWHO\FXWHLWKHUWKH)25&(VHWWLQJLVWRRORZRUWKHFXWWHUEODGHWLSLVQRWVXIÀFLHQWO\
extended.
6HH$GMXVWLQJWKH%ODGH/HQJWKDQG6HWWLQJWKH)RUFHDQGDGMXVWWKHVHWWLQJV
Adjustment when using plotting pen
$GMXVWWKH)25&(VRWKHUHZLOOEHQRIDLQWOLQHV7RSURORQJWKHSHQOLIHVHWWKH)25&(WRWKHORZHVWVHWWLQJ
without any faint lines. See"Setting the Force" or setting the FORCE.