Model 574 Programmable Counting System (PCS)
86 - GSE Scale Systems
number. This would permit you to enter a total from the
previous day or shift to continue the accumulation, or to
reset the number to 0. Simply enter the desired number
and press <ENTER>. You will then be prompted by a
display of MOD AC? for 1 second followed by ENTER
=MOD. Press <ENTER> to complete the change or any
other key to abort the modification of the accumulation
total.
The <CLR> key may be used to reset both the net and
gross totals to zero. The prompt CLEAR ACS? will
appear briefly followed by ENTER =CLR! Press
<ENTER> to complete the clearing or press any other
key to abort the clear operation.
NOTE:
If parameter P412 is enabled, any parameter that allows
for data to be directly entered, changed, cleared or
recalled into it is flagged with the letter “P” in front of
the parameters name. Refer to chapter 24 Pre-setable
Parameters on Data Registers and ID’s for a listing of
parameters that fall under this catagory. All
accumulation parameters fall under this catagory. More
information can be found in the OIML chapter.
8.5 PREVENTING DOUBLE
ACCUMULATIONS
A setup parameter (P164) can help to prevent accidental
double accumulations. This parameter lets you choose a
percent of capacity that the gross weight must fall below
before a second accumulation can take place.
If an accumulate is attempted without first removing the
last accumulated weight, the message CLEAR WGHT!
is displayed briefly and the operation is aborted.
NOTE:
Automatic accumulations can be acomplished
through the use of setpoints and macros. Refer to
the sections on Setpoints and Macros for an
explanation of these features.
To Next Page
Loading...