GSE 574 - Table 50 International Character Set

GSE Scale Systems - 289
Chapter 33 (OIML) Technical Reference Manual
Reference Manual for assistance with scrolling in alpha
entries.
If the OIML features are enabled (P410), then when
naming any of the "Preset-able Parameters", as listed in
table 49, the first character of the name will only be seen
when the parameter has been preset. For example, to
cause the tare name to print out as "T" for auto-tares and
"PT" for preset tares, the name "PT" should be given to
the tare using setup parameter P602.
In order to cause the same name to always be used for
one of these parameters, regardless of whether or not it
has been preset, enter a space as the first character of the
name. The space will be ignored in both the displayed
and printed name.
Note that an entered name is used both on the lower line
of the display when when the parameter is selected and it
is transmitted with the parameter when specified in a
custom transmit.
33.4 Check-sums on Transmitted Data
In Europe, if a printer is not located adjacent to the
SECTION - 33.3
# $ @ [ \ ] ˆ ` { | } ~
# $ à ° ç § ˆ ` é ù è ¨
# $ § Ä Ö ü ˆ ` ä ö ü ß
£ $ @ [ \ ] ˆ ` { | } ~
# $ @ Æ Ø Å ˆ ` æ ø ~
# ¤ É Ä Ö Å ü é ä ö ü
# $ @ ° \ é ˆ ù à ò è
$ @ ¡ Ñ ¿ ˆ ` ¨ ñ } ~
# $ @ [ ¥ ] ˆ ` { | } ~
# ¤ É Æ Ø Å ü é æ ø ü
# $ É Æ Ø Å ü é æ ø ü
# $ á ¡ Ñ ¿ é ü í ñ ó ú
# $ @ [ ] ˆ ' { | ˆ] ~
Selection# Name Description
0
USA United
States
1
Frnce France
2
Germn Germany
3
UK England
4
Dnmrk Denmark I
5
Swedn Sweden
6
Italy Italy
7
Spain Spain I
8
Japan Japan
9
Norwy Norway
10
Dnmrk2 Denmark II
11
Spn2 Spain II
12
LatAm Latin
America
35
23
36
24
64
40
91
5B
92
5C
93
5D
94
5E
96
60
123
7B
124
7C
125
7D
126
7E
Character Decimal
Number: Hex
International Character Set Re-mapped Characters
Table 50, International Character Set