GSE 574 - Page 116

GSE Scale Systems - 97
Chapter 13 Selectable Operating Modes Technical Reference Manual
Chapter 13 Selectable Operating
Modes
13.1 Selectable Operating Modes
P300 through P309
These parameters assign the order of appearance of the
available operational modes when the <SELECT> key
is pressed during weighing or counting. The mode
assigned by P300 would appear first (after the power-up
messages); the mode assigned to P301 would appear
next, followed by the mode assigned to P302, etc. In this
way, you can select for display only the operating modes
that will actually be used, including any of the
Accumulation Modes and Data Registers. The possible
selections are listed in the following table. (Note that
those modes that are not among the ten selectable modes
assigned in P300 - P309 may still be accessed during
weighing by keying in the corresponding mode number
and pressing <SELECT>. The direct access of modes
and registers may be inhibited by selecting disabled in
parameter P168.
The first three of the ten selectable modes inserted are
factory defaulted to Gross, Net and Tare. If desired
these three default parameters "can" be changed.
Examples:
As mentioned any of the data registers can be added to
the ten selectable modes. A practicle example for adding
a VAR to the selectable mode table would allow easy
access for changing setpoint target values. Another
example mentioned are the accumulation modes. Instead
of remembering which accumulation mode to select and
the individual keys to get there, add the specific
accumulation mode to the table. Refer to Table 10,
Parameter ID Numbers for a complete listing.
SECTION - 13.1
Parameter ID Transmitted Name
Gross Weight
00
Gross
Net Weight
01
Net
Tare Weight
02
Tare
Gross Total
03
GrTOT
Gross Total + Current
04
GrT+C
Gross Total - Current
05
GrT-C
Net Total
06
NtTOT
Net Total + Current
07
Nt+C
Net Total - Current
08
Nt-C
Time / Date
11
Tm/Dt
Truck IN / OUT Gross Wt.
12
TrGrs
Truck IN / OUT Net Wt.
13
TrNet
Truck IN / OUT Tare Wt.
14
TrTar
ID #1 (alpha-numeric, 49 characters max.)
21
(programmed in P701)
ID #2 (alpha-numeric, 49 characters max.)
22
(programmed in P703)
ID #3 (alpha-numeric, 49 characters max.)
23
(programmed in P705)
ID #4 (alpha-numeric, 49 characters max.)
24
(programmed in P707)
ID #5 (alpha-numeric, 49 characters max.)
25
(programmed in P709)
ID #6 (alpha-numeric, 49 characters max.)
26
(programmed in P711)