GSE 574 - Chapter 16 Macro Programming Operations; 16.1 Overview

Model 574 Programmable Counting System (PCS)
120 - GSE Scale Systems
is mode "n".
IF NOT %N CEH 206
IF setpoint "n" n%O CFH 207
activated
PAUSE %P D0H 208
Send "n"th custom n%Q D1H 209
transmit.
IF register "n", n%R D2H 210
is not zero.
SOUNDS Beeper %S D3H 211
TAG current position. %T D4H 212
- FACTORY USE - %U D5H 213
IF setpoint input "n" n%V D6H 214
is active.
WAIT for operator %W D7H 215
to press any key.
- FACTORY USE - %X D8H 216
IF operator presses %Y D9H 217
<ENTER>.
- FACTORY USE - %Z DAH 218
SAVE entry. %[ DBH 219
IF no entry. %\ DCH 220
RETRIEVE entry. %] DDH 221
GO TO macro "n" n%^ DEH 222
IF Database error "n" n%_ DFH 223
- FACTORY USE - %` E0H 224
- FACTORY USE - %a E1H 225
DESCRIPTION RS-232 (ASCII) 8 BIT HEX 8 BIT DECIMAL
- FACTORY USE - %b E2H 226
CLR %c E3H 227
- FACTORY USE - %d E4H 228