Model 574 Programmable Counting System (PCS)
198 - GSE Scale Systems
bytes copied is the smaller of the sizes of either
E
2
.
j. When the copy is done, the message Copy Done
is displayed briefly. Next the messages Power
Down ... to Save! are alternately displayed for
one second each until either power is removed
or until any key is pressed. All parameters will
have been copied from the E2 in U1 to U2,
including the instrument and board serial
numbers and the Audit Trail counter
(parameters P602XX). However, these three
parameters are cleared from U1 to prevent
duplicate serial numbers. Thus U1 contains all
its original setup data except these P602XX
parameters. If <ZERO>, <SELECT> or any of
the numeric keys are pressed then the P602XX
parameters are copied back to U1 and deleted
from U2. U2 will still contain a copy of all the
other stored data except the P602XX
parameters.
k. Remove the unit from the AC power source.
l. Remove the original E
2
from U1. Move the
new E
2
from U2 to the U1 socket. If desired
(for more storage room) place an E
2
in the U2
position also. This can be either the E
2
removed from U1 or another E
2
.
m. Re-attach the plastic top to the 574’s chassis.
n. The instrument is now ready to be used with
the upgraded amount of E
2
storage memory.
19.3 Additional Memory and Replacement
Part numbers
Additional GSE part numbers for the 574 memory
expansion are listed below. GSE part #: (09-30-24164)
is factory installed in the unit. This is 2048 bytes of
memory. An additional 2048 bytes of memory can be
added for a total of 4096 bytes of memory. The
additional E
2
part number is the same as the factory
installed device and its part number is listed below.
- 2048 bytes GSE part #: (09-30-24164)
To Next Page
Loading...