GSE 574 - Appendix 4 ASCII to Hexadecimal Conversion Chart

Model 574 Programmable Counting System (PCS)
286 - GSE Scale Systems
This parameter allows for enabling or disabling the remote
550’s numeric keypad including the decimal point. If
enabled it will have an effect on the master unit. When any
of the numeric keys are pressed it will send that specific
character to another GSE instrument. Both a TX, RX and
GND line must be connected between the two units
COMM Ports for remote key operation. Both units must be
set for software handshake (Xon). If this parameter is
disabled the numeric keypad will have no effect on the
master unit.
32.7 Remote and Master Unit Parameter
Listing in Serial Text Formats
(M450 remote)
160%s9990%e%e P160.--Model 450
OR
160%s9992%e%e P160.--Model RmDsp
270%s0%e P270.00 TmOut Disbl
271%s0%e P271.00 Formt Dsply
274%s2%e P274.02 Start <STX>
275%s3%e P275.03 End <ETX>
280%s1%e P280.01 ZERO Enbld
281%s1%e P281.01 UNITS Enbld
282%s1%e P282.01 SELCT Enbld
283%s1%e P283.01 ID Enbld
284%s1%e P284.01 PRINT Enbld
285%s1%e P285.01 TARE Enbld
287%s1%e P287.01 CLEAR Enbld
(M550 remote)
160%s9990%e%e P160.--Model 550
OR
160%s9992%e%e P160.--Model RmDsp
270%s0%e P270.00 TmOut Disbl
271%s0%e P271.00 Formt Dsply
274%s2%e P274.02 Start <STX>
275%s3%e P275.03 End <ETX>
280%s1%e P280.01 ZERO Enbld
281%s1%e P281.01 UNITS Enbld
282%s1%e P282.01 SELCT Enbld
283%s1%e P283.01 ID Enbld
284%s1%e P284.01 PRINT Enbld
285%s1%e P285.01 TARE Enbld
286%s1%e P286.01 ENTER Enbld
287%s1%e P287.01 CLEAR Enbld
288%s1%e P288.01 NUMBR Enbld
(M450 master)
290%s0%e P290.00 Echo Disbl
291%s2%e P291.02 Start <STX> ^B=02
292%s3%e P292.03 End <ETX> ^C=03
(M550 master)
290%s0%e P290.00 Echo Disbl
291%s2%e P291.02 Start <STX> ^B=02
292%s3%e P292.03 End <ETX> ^C=03
(M574 master)
290%s0%e P290.00 Echo Disbl
291%s2%e P291.02 Start <STX> ^B=02
292%s3%e P292.03 End <ETX> ^C=03