GSE 574 - Page 5

GSE Scale Systems
Motion Delay
Filter
Auto-Filter
Display Update Rate
Zero Range
Linearization
Chapter 4 Parameter Setup Mode (Advanced) 17
4.1 Getting into the Parameter Setup Mode 17
4.2 Using the Parameter Setup Mode 17
4.3 Exiting the Parameter Setup Mode 17
4.4 Parameter Types 18
4.5 Character Entry 19
4.6 Parameter Listing (P110 - P65010 Software Map) 19
Chapter 5 Weighing Mode 67
5.1 Weighing Mode 67
5.2 Front Panel Key Operation 67
Chapter 6 Counting Mode 69
6.1 Parts Counting Mode 69
Operation of the Sample Key
Sampling to Determine a Piece weight
Negative Sampling to Determine a Piece Weight
Use of the Auto-Enhance Feature
Using the Minimum Accuracy Feature
Achieved Accuracy is Less than Required
Achieved Accuracy Meets Requirements
Counting Parts
Recommended Setup
6.2 Front Panel Key Operation 74
6.3 Parts Counting Parameter Setup 74
6.4 Counting Mode Listing 75
Chapter 7 Calibration Mode 77
7.1 Calibration Mode 77
7.2 Multi-Point Linearization 81
7.3 Quick Calibration 82
Quick Cal Introduction
Quick Cal Commands
IV