GSE Scale Systems - 41
Chapter 4 Parameter Setup (Advanced) Technical Reference Manual
PARAMETER # SELECTION DESCRIPTION
SECTION - 4.6
DATABASE SETUP
P731.XX This parameter is used to setup the
columns for database 1. P731 is
available if P720 has been set to either
database or menu. The entry
procedure is the same as for P701.
P732 through P746 These parameters are used to set up
databases 2 through 16. They are
available if P720 has been set to either
database or menu. The entry
procedure is the same as for P701.
MACRO
PROGRAMMING
P800.00 Mac 0 * XXXXX Enter macro #0 setup.
P801.00 Mac 1 * XXXXX Enter macro #1 setup.
P802.00 Mac 2 * XXXXX Enter macro #2 setup.
P803.00 Mac 3 * XXXXX Enter macro #3 setup.
P804.00 Mac 4 * XXXXX Enter macro #4 setup
P805.00 Mac 5 * XXXXX Enter macro #5 setup.
P806.00 Mac 6 * XXXXX Enter macro #6 setup.
P807.00 Mac 7 * XXXXX Enter macro #7 setup.
P808.00 Mac 8 * XXXXX Enter macro #8 setup.
P809.00 Mac 9 * XXXXX Enter macro #9 setup.
P810.00 Mac10 * XXXXX Enter macro #10 setup.
P811.00 Mac11 * XXXXX Enter macro #11 setup.
P812.00 Mac12 * XXXXX Enter macro #12 setup.
P813.00 Mac13 * XXXXX Enter macro #13 setup.
P814.00 Mac14 * XXXXX Enter macro #14 setup.
P815.00 Mac15 * XXXXX Enter macro #15 setup.
P816.00 Mac16 * (#16/Special macro) Enter macro #16 setup.
MACRO NAMES
P850.-- Mac0 * None! Macro #0 (see chp. 16)
P850.-- XXXXX Key in Macro Name.
P851.-- Mac1 * None! Macro #1 (see chp. 16)
P851.-- XXXXX Key in Macro Name.
P852 through * XXXXX Macros #2 through #16
P866
To Next Page
Loading...