GSE Scale Systems - 61
Chapter 4 Parameter Setup (Advanced) Technical Reference Manual
PARAMETER # INFORMATION DESCRIPTION
P61220. AIN8 NROff X Analog IN: This parameter
compensates for the non-ratiometric
offset.
P61221. VREF NROff X Compensation of Reference Voltage.
If the sense leads are shorted, then the
reference voltage should be zero. If
the leads are not shorted, this factor
will compensate for the error.
P61222. SN: XXX This is the serial number of the A/D
on the remote scale option board.
P61230. -CAL- WGHT1 Displays weight used
for the first cal point of
the Multi-Point
Linearization feature (if
enabled).
P61231. -CAL- FACT1 Displays cal adjustment
factor for weights less
than or equal to the
weight shown in the
preceeding parameter.
P61232. -CAL- WGHT2 Displays weight used
for the 2nd cal point of
the Multi-Point
Linearization feature (if
enabled).
P61233. -CAL- FACT2 Displays cal adjustment
factor for weights less
than or equal to the
weight shown in the
preceeding parameter.
P61234. -CAL- WGHT3 Displays weight used
for the 3rd cal point of
the Multi-Point
Linearization feature (if
enabled).
SECTION - 4.6
To Next Page
Loading...