Model 574 Programmable Counting System (PCS)
68 - GSE Scale Systems
blank out when motion is present.
SELECT
Pressing <SELECT> will toggle you through
the Net Weight, Tare Weight and Gross Weight,
Quantity, APW or other enabled operating
modes. Refer to the Mode Selection
parameters, P300 - P309.
TARE
Pressing <TARE> by itself will perform an
auto-tare. A Net Zero is then displayed. You
can enter a known Tare Weight into the 574 by
keying in the number and pressing <TARE>.
In either case, the indicator will be placed in the
Net Mode, unless you are in the Tare Mode.
Auto-Tare and / or Keyboard Tare may be
disabled in the Setup Mode (P166, P167).
PRINT/ENTER
Press to send data to a printer, computer or other
device. This key also doubles as an <ENTER>
key following certain numeric entries.
ID
This key has four functions, entering ID's, truck
operations, macro menu selection and database
access. The exact function of this key depends
on the selectable internal setup.
F1, F2, F3, F4 and F5
Keys <F1> through <F5> will invoke custom
macro programs. The custom macro allows
multiple operations to be executed
consecutively without interuption from the
operator unless prompting the operator is part of
the macro program. Refer to the technical
reference manual for more information on
macro programming. The <F1> and <F4> keys
double as Up and Down arrow keys
respectively. While having accessed any mode
or parameter which requires a character entry,
the <F1> key will scroll through a set of ASCII
characters. The <F4> key will scroll through
the set in reverse. The <F5> key or Right
Arrow when pressed will move over to the next
character position. The <F3> key or Left
Arrow will backup to the previous character.
As entries are keyed into the entry buffer, the
<PRINT/ENTER> key will complete the entry.
When in the weigh or quantity modes, the unit
is ready to accept a structured ASCII file for
custom setups. The custom setup is received
through the units bi-directional communications
port at the rear of the 574 identified as (COM).
UP ARROW
DOWN ARROW
RIGHT ARROW
LEFT ARROW
These keys are used when making character
entries to create Custom Setups in the program
mode. Holding down the UP ARROW key will
scroll through the full ASCII character set.
Pressing the DOWN ARROW will scroll
through the ASCII character set in reverse.
Once the correct character is in view, the
RIGHT ARROW will move to the next
character location. Use the UP/DOWN
ARROWS to select the next character. Press
< ENTER > when the selections are completed.
0 thru 9 and “.”
Press these keys to enter 0 thru 9. Press the
decimal point key to establish a decimal point.
CLR
Press this key to clear a numeric entry mistake
prior to entering it into memory.
To Next Page
Loading...