GW Instek PSW Series - Page 105

CONFIGURATION
105
Falling Current
Slew Rate
Sets the falling current slew rate. Only
applicable if V-I Mode is set to CC Slew Rate
Priority.
F-07
0.01A/s~72.00A/s (PSW 30-36)
0.1A/s~144.0A/s (PSW 30-72)
0.1A/s~216.0A/s (PSW 30-108)
0.01A/s~27.00A/s (PSW 80-13.5)
0.01A/s~54.00A/s (PSW 80-27)
0.01A/s~81.00A/s (PSW 80-40.5)
0.01A/s~14.40A/s (PSW 160-7.2)
0.01A/s~28.80A/s (PSW 160-14.4)
0.01A/s~43.20A/s (PSW 160-21.6)
0.001A/s~9.000A/s (PSW 250-4.5)
0.01A/s~18.00A/s (PSW 250-9)
0.01A/s~27.00A/s (PSW 250-13.5)
0.001A/s~2.880A/s (PSW 800-1.44)
0.001A/s~5.760A/s (PSW 800-2.88)
0.001A/s~8.640A/s (PSW 800-4.32)
Internal
Resistance
Settings
Sets the internal resistance of the power supply.
F-08
0.000Ω ~0.833Ω (PSW 30-36)
0.000Ω ~0.417Ω (PSW 30-72)
0.000Ω ~0.278Ω (PSW 30-108)
0.000Ω ~5.926Ω (PSW 80-13.5)
0.000Ω ~2.963Ω (PSW 80-27)
0.000Ω ~1.975Ω (PSW 80-40.5)
0.000Ω ~22.222Ω (PSW 160-7.2)
0.000Ω ~11.111Ω (PSW 160-14.4)
0.000Ω ~7.407Ω (PSW 160-21.6)
0.00Ω ~ 55.55Ω (PSW 250-4.5)
0.00Ω ~ 27.77Ω (PSW 250-9)
0.00Ω ~ 18.51Ω (PSW 250-13.5)
0.0Ω ~ 555.5Ω (PSW 800-1.44)
0.0Ω ~ 277.8Ω (PSW 800-2.88)
0.0Ω ~ 185.1Ω (PSW 800-4.32)