GW Instek PSW Series - LAN Settings

CONFIGURATION
107
Rear Panel USB
State
Displays the rear panel USB-B port state. This
setting is not configurable.
F-21
0 = Absent, 2 = USB-CDC,
3 = GPIB-USB adapter
Rear Panel USB
Mode
Sets the rear panel USB mode.
Note: Option #3, USB CDC Full Speed Only,
can be used to reduce the data transmission
speed when there are sources of interference in
the operating environment. This option is only
available for firmware version 1.42 and above.
F-22
0 = Disable, 1 = GPIB-USB
adapter, 2 = Auto detect speed,
3 = Full speed only
GPIB Address
Sets the GPIB address.
F-23
0~30
LAN Settings
MAC Address-
1~6
Displays the MAC address 1~6. This setting is
not configurable.
F-30~F-35
0x00~0xFF
LAN
Turns Ethernet on or off.
F-36
0 = Disable, 1 = Enable
DHCP
Turns DHCP on or off.
F-37
0 = Disable, 1 = Enable
IP Address-1~4
Sets the default IP address. IP address 1~4
splits the IP address into four sections.
(F-39 : F-40 : F-41 : F-42)
(0~255 : 0~255 : 0~255 : 0~255)