GW Instek PSW Series User Manual

CONFIGURATION
111
Master/Slave
Sets the power supply as master or slave. See
the parallel/series operation for details, page
72.
F-93
0 = Master/Local
1 = Master/Parallel1
2 = Master/Parallel2
3 = Slave/Parallel
4 = Slave/Series (Only for 30V,
80V, 160V models)
External Out
Logic
Sets the external logic as active high or low.
F-94
0= High ON, 1 = Low ON
Power Switch Trip
Turns the power off if enabled when the
protection settings are tripped.
F-95
1 = Disable, 0 = Enable
Calibration
Programmable
Calibration
The calibration password is used to access the
local mode calibration or other special
functions. The password used determines
which function is accessed. Please see your
distributor for details.
F-00
0000 ~ 9999

GW Instek PSW Series Specifications

General

Ripple & Noise (CC)	≤ 3mArms
Protections	OVP, OCP, OTP
Remote Sense	Yes
Programmable	Yes
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Voltage Resolution	1mV
Current Resolution	1mA
Current Accuracy	±0.1% + 10mA
Ripple & Noise (CV)	≤1mVrms
Load Regulation (CC)	≤0.1% + 5mA
Line Regulation (CC)	≤0.1% + 5mA
Remote Interface	USB, RS232
Display	LCD